Zircuti components for Brian Brown Corvus (All variants)
*Due to varying finishes from the nature of ziructi, the zircuti parts in the photo may differ from the ones you receive.* This kit contains one pivot collar, one pivot island, one backspacer, and one pocket clip. Your original factory hardware will be reused.
Check out the Brian Brown Corvus by clicking HERE.
READ BELOW BEFORE PURCHASING!! YOU ACCEPT THE FOLLOWING CONDITIONS BELOW IF YOU PURCHASE THIS PRODUCT!!
1) SliceFK and Brian Brown Knives ARE NOT RESPONSIBLE FOR DAMAGE CAUSED TO KNIFE WHEN INSTALLING THIS KIT, INSTALL AT YOUR OWN RISK!
2) BY PURCHASING THIS PRODUCT, YOU KNOWINGLY ACCEPT THAT THE BACKSPACER, PIVOT COLLAR, POCKET CLIP COLORING, AND/OR PATTERN MAY NOT MATCH!
3) There is a pin in the original backspacer of your Corvus, it may or may NOT be able to be reused on the Zircuti backspacer depending on the tolerances of the pin and the new Zircuti backspacer.
4) NO THESE WILL NOT FIT A CUSTOM KNIFE FROM BRIAN BROWN.
5) THESE WILL FIT ALL CORVUS VARIANTS.
If replacement parts are needed after disassembly such as pivots, washers, bearings, etc those replacement parts can be found on Brian Brown's website by clicking HERE. PLEASE disassemble your knife carefully so as to not damage or lose any parts as there will be a charge for all replacement parts.
